Hamilton Beach HBB908 User Manual download pdf (Page 9)

Troubleshooting Guide

Replacement Parts for Model HBH908

Problem . . . Solution . . .

Blender fails to start

or stops while it is

running and cannot

be restarted

• Check to see if unit is securely plugged into an electric outlet.

• Check to see if the fuse for the electric outlet has blown or if a circuit breaker

has tripped.

Maintenance

Unplug the blender and remove the container from the base, and then inspect the

container and cutter unit assembly for wear, nicks, and broken or loose blades. Replace if

necessary. If the blades are loose, discontinue use immediately and replace the blades.

Do not attempt to repair or tighten the cutter assembly. See “Replacement Parts” below.

Unplug the blender, and then inspect the power cord insulation and power plug for cracks.

Refer to “Technical Service” for repair or replacement.

Replace the container and cutter assembly at least every 90 days. See “Replacement

Parts” below.

44 oz. polycarbonate container 6126-HBB908

Cutter assembly HBB99100

Part Description

Part Number

Inspect the blender and its various parts and replace as follows:

Daily

Weekly

Quarterly

Ingredients will not mix

properly

• Check to see if enough liquid has been added to the ingredients. Mixture should

be fluid and free-running at all times.

• Solid pieces are too large. Pieces should not exceed 1″ (25 mm) cubes.

• Container is too full. Do not fill past highest graduation marking.

• Cutter unit blades are not sharp or are damaged. Inspect container and cutter

assembly daily. Replace cutter assembly at least every 90 days or sooner if cutter

assembly appears worn or damaged.

• Check to see if cutter assembly is installed properly.

• Select speed to create a fluid blend.

For replacement parts, call toll free: 866-285-1087.

Caring for the Blender

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

Hamilton Beach HBB908 User Manual Page 9