Hamilton Beach 54614 User Manual download pdf (Page 5)

5

How to Assemble

IMPORTANT: Your blender jar and

cutting assembly are subject to wear

during normal use. Always inspect

jar for nicks, chips, or cracks. Always

inspect cutting assembly for broken,

cracked, or loose blades. If jar or

cutting assembly is damaged, do not

use. Call our toll-free customer service

number to obtain replacement parts.

1. Make sure blender is unplugged.

Place blender base on clean, dry

surface.

2. Fit gasket over blades as shown in

illustration on page 4. The gasket

must lie flat. Set jar on top of gasket

and screw on cutting assembly.

Make sure the cutting assembly is

firmly screwed onto the jar.

3. Set jar into place on blender base,

making sure it is securely seated.

If not, gently rock the jar until seated.

OPTIONAL: When dispenser is

not needed,

replace

dispenser with

spout cap.

Remove

dispenser by

rotating

counter-

clockwise

(see “How to

Clean” section). Insert spout cap

on jar. Turn spout cap clockwise to

tighten.

4. When spout cap is not in use, snap

onto bottom of blender base for

storage.

How to Operate

1. Plug cord into outlet.

2. Put ingredients in jar. Place lid with

filler cap on jar.

3. Process food or beverages.

NOTE: When blending thin liquids,

do not fill above the 32-ounce/

4 cup/1000 ml mark on blender jar.

4. ALWAYS turn blender off and wait

until blades have stopped rotating

before removing jar.

5. To remove jar after blending is

complete, lift the jar straight up. If

it is not easily removed, rock gently

and lift. Do not twist.

To Use the Dispenser:

To dispense thick liquids (such as

milkshakes, smoothies, frozen

drinks, etc.), turn the control knob to

DISPENSE and pull Dispenser Lever

up. Turn OFF after dispensing.

NOTE: Blender MUST be ON to

dispense thick liquids and frozen drinks.

When dispensing thin liquids, it may not

be necessary to turn the blender ON to

dispense the liquid.

NOTE: NEVER replace jar onto unit

while motor is running.

840155505 ENv01.indd 5840155505 ENv01.indd 5 7/19/12 1:13 PM7/19/12 1:13 PM

1 2 3 4 5 6 7 8 9 10 ... 27 28

Comments to this Manuals

No comments