Hamilton Beach CPM700 User Manual download pdf (Page 14)

14

Preparing to clean

Always clean the stand mixer immediately

after use. Cleaning (and sanitizing) is also

recommended between batches when

processing different foods.

1. Make sure the unit is off and unplug

the unit.

2. Remove the bowl and any attachments.

The bowl and attachments should

be cleaned as instructed at right or

in accordance with local health

department regulations.

3. Wipe the base with a damp cloth, lightly

soaked in a water soluble detergent.

The use of a small brush is helpful in

removing food from crevices. Wipe the

base with a damp cloth lightly soaked

in clean water. Wipe with a cloth lightly

soaked in sanitizing solution and allow

to air dry.

Recommended Cleaning and

Sanitizing Procedures

Never use a wire brush, steel wool or bleach

when washing the stainless steel bowl. Use

vinegar to remove hard water deposits.

The beater, wire whisk, and dough hook

will discolor if washed in a dishwasher. Hand

washing in a three tank system pot sink

(wash, rinse, and sanitize) is recommended

for the longest life of these parts.

1. Pre-rinse each attachment to remove any

food residue. The use of a power sprayer

can be helpful in cleaning out tight

crevices. DO NOT powerspray the

machine base.

2. Wash all attachment parts in warm (at

least 120° F) water with an approved

detergent. Rinse in clear water then in

an approved sanitizing solution. Allow

to air dry before reassembling.

Recommended Sanitizing Solution:

The sanitizing solution should consist of 1

tablespoon of household bleach per 1 gallon

of clean, cool water (60° F, 16° C) mixed

according to the instructions on the bleach.

When using a sanitizing solution other than

that recommended, the sanitizing solution

concentration should be tested using com-

mercially available test strips and should

indicate a concentration between 100 and

200 parts per million of bleach to water.

wWARNING

Electrical Shock Hazard

Disconnect power before cleaning.

Replace all parts before operating.

Failure to do so can result in death

or electrical shock.

Cleaning and Sanitizing Instructions

64384ENv04 11/9/01 11:11 AM Page 14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Comments to this Manuals

No comments